The Basics Of Hardwood Floor Repair
This article presents guidelines regarding basic hardwood floor repair, which is essential because a small damaged area can destroy the appearance of your entire floor. Fortunately, the process is quite easy if you have the appropriate instructions and tools before you perform it. It is also important to remember that the procedure will be very similar even if you have engineered hardwood flooring. The only difference is that you will be need to be extra careful when sanding the engineered flooring to avoid sanding through the top layer. Some of the tools needed are a ruler, circular saw, belt sander, utility knife, mallet, hammer, chisel, miter saw, table saw, sand paper, nail gun, and tack cloth. After you have prepared all of these tools and you have an idea on how to do the process, you are ready to perform your hardwood floor repair.
The initial step to take in hardwood floor repair is the removal of the affected hardwood plank. You will need to draw a line through the middle of the plank and this will be your guide in cutting the plank to allow you to remove it. Make sure that your saw has been set up to cut only through the hardwood plank and not the sub-floor. Then, you can cut through the ends using your ruler and utility knife. This may require several cuts before you are able to completely cut through the plank. After this, you can slowly and carefully extract the damaged plank.
Sanding hardwood floors is the next step in your repair of the hardwood floor but this process is quite simple because you only need to sand a specific area and not the entire floor. Rough sandpaper or a belt sander may be utilized to get rid of the damaged part. After you have completed the sanding, you can replace the plank. You may need to cut off the lower half of the groove so that it can fit in. After the plank has been inserted, make a few taps with the rubber mallet to ensure that the plank is securely placed. The final step is to apply the finish while ensuring that the shade is compatible with nearby planks.
Meanwhile, if there is a squeak when you walk on the hardwood floor, this will require a different hardwood floor repair procedure. The first thing to do is go down one floor and stand directly underneath the flooring. The goal is to search for any break or movement of the sub-floor if a person above steps on the problem area. If you notice that both are present, you can place a bead of adhesive on one face and the top edge of a short two inch by four inch board and then affix this piece of wood to the joist by nailing it upward so that the board is tightly connected to the sub-floor. Another way is to place a large weight on the squeaking board and then use a sheet-metal screw to affix it to the sub-floor.
